Skip to main content

Accu-Strut XDrill strut for Ruger Minis - SS

Accu-Strut

$160.00
(No reviews yet) Write a Review
SKU:
Accu-strut XDrill-SS
Condition:
New
Adding to cart… The item has been added

Barrel strut for Mini-14 and Mini-30 rifles. Provides mechanical rigidity for thin carbine barrel, reducing accuracy-killing vibrations. The 6-inch 2-clamp configuration gives your best opportunity for performance increases. Typical improvement is 50-75% reduction in group size for earlier straight-barrel rifles, and up to 33% on the new tapered barrels. Your actual experience will vary.

New super-lightweight version. Features cross-drilled lightening holes.

  • Lightening holes for weight reduction

  • Hollow endplug for weight reduction and preventing contamination

  • About an ounce lighter than LT model

  • Acccurization performance about the same as the LT model.

  • Also significantly aids in barrel over-heating problems, reduces load sensitivity, and enhances the appearance of your Mini.

  • Proprietary Flex-clamp design accomodates newer tapered barrels, an Accu-strut exclusive.

  • Available in black oxide (“blued”), stainless steel, or combination finish.

Dimensions:

  • Length: 5-7/8"
  • Weight: 7.0 oz

The Accu-strut will generally fit on any series Mini-14 or Mini-30, except for some important exceptions:

  • Early Minis use a version of the gas block that does not incorporate a center flange. The strut will still install on these models, but note that there will be no place to attach the rear set-screws. This may lead to a slippage problem with no easy way to fix.

  • Early GB models with folding stock and the newest Mini 14 tactical Model 5895 with Walnut folding stock have a special version of the gasblock that have a side attachment point for the sling, and no center flange. Again, no rear attachment point, and possible slippage problems.

2-Clamp Models (LT, XDrill)

 

 

 

 

 

 

 

 

 

 

Compatibility


Harris bipod adaptor
: strut sits forward a bit to accommodate "forks". May not be able to use the rear set-screws.

ASI Tuneable Gas Block: The Accu-strut will not work with this product due to interference with the adjustment screw.

Ultimak rail: Rear clamp must be shifted forward a bit to clear extended rail.

Amega Ranges rail: installs with no modification.

Videos Hide Videos Show Videos